聚焦慢速高荷态重离子束微束斑X射线源

利用电子束离子源(EBIS)或者电子束离子陷阱(EBIT)产生的慢速高电荷态重离子束轰击金属靶面,离子束与靶面作用并复合辐射特征X射线;并将高荷态离子束采用离子光学系统会聚为微细束后再与靶面作用,能够辐射出微米甚至亚微米级、纳米级的微束斑X射线.本文介绍这一新型微束斑X射线源的结构、机理及其特性等.     

强流束晕-混沌的外部磁场开关控制

研究了强流离子束在周期聚焦磁场通道中束晕-混沌的外部磁场开关参数控制方法. 将该方法应用在多粒子模型中，实现了对5种不同初始分布质子束的束晕-混沌的有效控制，得到了消除束晕及其再生现象的理想结果.在强流加速器系统中，由于外部磁场是可测和可调 的物理量，因此该控制方法有利于实验研究，可为强流质子加速器中周期聚焦磁场的设计和实验提供参考. 关键词： 强流离子束 周期聚焦磁场通道 束晕_混沌 混沌控制 开 关控制     

能动反射镜低频像差补偿能力分析

 采用Algor软件包并利用有限元法对37单元能动反射镜低频误差补偿能力进行了分析计算，确定了镜面厚度8mm，驱动器间距46mm，极头直径12mm等能动反射镜制造的关键参数。通过计算机仿真分析证明，基于这些参数所设计的能动反射镜可以对低频误差进行有效校正，校正精度的均方根值小于等于λ／８，从而可以为能动反射镜的制造提供理论依据。     

高功率激光驱动器中小尺度自聚焦和噪声模型

 建立了一套线性的近似分析方法，研究高功率激光驱动器中强激光传输的小尺度自聚焦效应和相位噪声对光束传输和光束质量的影响，给出了系统噪声强度、B积分值与光束近场调制对比度之间的定量关系。研究表明,为保证输出光束质量，即近场调制对比度小于给定值，系统内的噪声强度必须符合一定的谱分布。     

用多路逆磁系统测量热电子环磁镜中热电子沿轴向的分布

本文介绍了多路逆磁测量方法及利用这一方法在ＨＥＲ装置上测量热电子环沿轴向的长度与晃荡电子密度的轴向分布的实验结果。     

Application of Novel Focusing Mirrors in Gyrotron Transmission Lines

A novel focusing mirror based on the shifting of the beam phase according to the Gaussian beam optics enabled us to realize a focusing elements with different focal lengths in different directions and to convert the gyrotron output into a Gaussian-like beam. In this paper, we compare the quality of beams produced by the new system (which includes novel mirrors) and a conventional system consisting of a quasi-optical antenna, an ellipsoidal mirror and two parabolic cylinder mirrors.     

A possibility of parallel and anti-parallel diffraction measurements on neutron diffractometer employing bent perfect crystal monochromator at the monochromatic focusing condition

In a conventional diffractometer having single monochromator, only one position, parallel position, is used for the diffraction experiment (i.e. detection) because the resolution property of the other one, anti-parallel position, is very poor. However, a bent perfect crystal (BPC) monochromator at monochromatic focusing condition can provide a quite flat and equal resolution property at both parallel and anti-parallel positions and thus one can have a chance to use both sides for the diffraction experiment. From the data of the FWHM and the Δd/d measured on three diffraction geometries (symmetric, asymmetric compression and asymmetric expansion), we can conclude that the simultaneous diffraction measurement in both parallel and anti-parallel positions can be achieved.     

Induced focusing and conversion of a Gaussian beam into an elliptic Gaussian beam

We have presented an investigation of the induced focusing in Kerr media of two laser beams, the pump beam and the probe beam, which could be either Gaussian or elliptic Gaussian or a combination of the two. We have used variational formalism to derive relevant beam-width equations. Among several important findings, the finding that a very week probe beam can be guided and focused when power of both beams are well below their individual threshold for self-focusing, is a noteworthy one. It has been found that induced focusing is not possible for laser beams of any wavelength and beam radius. In case both beams are elliptic Gaussian, we have shown that when power of both beams is above a certain threshold value then the effective radius of both beams collapses and collapse distance depends on power. Moreover, it has been found that induced focusing can be employed to convert a circular Gaussian beam into an elliptic Gaussian beam.     

Study on the possibilities of controlling the laser output beam properties by an intracavity deformable mirror

The possibilities of controlling the laser beam properties by a deformable mirror introduced into the laser optical cavity were studied theoretically and experimentally. The experiments were performed under conditions of an industrial high power transverse flow cw CO₂ laser operating with a stable resonator of a folded configuration. A deformable bimorph mirror of a surface profile controlled by the voltage applied to the mirror electrodes is implemented to the laser system as a back cavity mirror or as a one of the inner folding mirrors. The near-and far-field characteristics of the laser beam versus the resonator configuration controlled by the changes of the focal length of the deformable mirror are discussed in the paper. The analysis reveals that the resonator with an inner deformable mirror is much more sensitive to the mirror curvature variations than the resonator in which the deformable mirror is used as a back cavity mirror. The presented results show that dynamic and controllable changes in the resonator properties result in the controlled modification and optimisation of the laser output power and spatial parameters of the laser radiation.     

Evaluation of Coulomb Energy Difference for Light Mirror Nuclei Using Slater—Type Orbitals

Behavior of the Coulomb energy difference for light nuclei is explained in terms of the different values of the average Coulomb interaction between two particles.Coulomb energy difference according to shell model of light mirror nuclei in the Coulomb and exchange integrals in the formula can be explained with exponential-type wavefunctions.In this study,using the one-center expansion of exponential-type wavefunctions in terms of Slater-type orbitals with the same center,we derived formula for Coulomb energy difference of light mirror nuclei.